A.3 mm
B.6 mm
C.12 mm
D.25 mm
E.30 mm
Related Mcqs:
- In arc welding as the thickness of the material to be welded increases, the welding current requirement
- Two 20 mm thick plates are to be gas welded. What size of welding rod should be selected out of the following rods available?
- What should be the thickness of a cast iron pipe 45 cm diameter if it is required to sustain 6 kg/sq cm inside pressure ? The maximum stress in the pipe material being limited to 140 kg/cm2
- Three rods one made of glass, one of pure aluminium and one made of wrought iron are heated to 150?C. All the rods are 15 mm in diameter and 300 mm long. The lowest temperature at the free end of the rods will occur in case of
- Two rods A and B are subjectd to equal load P. Rod A is tapering with bigger diameter D at the support and small end diameter as D/2. Rod B is of uniform cross section with diameter D. The ratio of elongation of rod A to that of B would be
- In electrical resistance welding cleaning of metals to be welded
- Two rods one of copper and the other of mild steel, both of diameter 20 mm and length 250 mm are coated with a uniform layer of wax all around. These rods are placed vertically in a boiling water bath with 200 mm, length of each rod projecting outside. If the melting point of wax is 10?C, then
- A thin cylinder contains fluid at a pressure of 30 kg kg/cm2, the internal diameter of the shell is 60 cm and the tensile stress in the material is to be limited to 900 kg/cm2. The shell must have a minimum wall thickness of
- A thin cylinder contains fluid at a pressure of 30 kg/cm2, the inside diameter of the shell is 60 cm and the tensile stress in the material is to be limited to 900 kg/cm2. The shell must have minimum wall thickness of
- A seamless water main 1 metre in diameter is required to carry wter under a head of 100 metres. If the maximum permissible tensile stress in the metal is 500 kg/cm2, the thickness of metal required would be
