A.1 mm
B.5 mm
C.10 mm
D.15 mm
E.25 mm
Related Mcqs:
- A spherical metal vessel 120 cm diameter is subjected to an internal pressure of 15 kg/sq cm. If the permissible stress is 625 kg/sq cm and the efficiency of the riveted joints is 75%, the required thickness of the plate would be
- A bolt of nominal diameter 33 mm having a safe tensile stress of 100 N/mm2 can safely carry a load of
- In a pumping installation the suction line is is 4 metre long and suction pipe diameter is 100 mm. Now if the suction pipe is replaced by a pipe combination consisting of 2 metres of 100 mm diameter pipe joined with 2 metres of 150 mm diameter pipe, the suction heat will become
- With a punch for which the maximum crushing stress is 4 times the maximum shearing stress of the plate, the biggest hole that can be punched in the plate would be of diameter equal to
- A cupola one metre in diameter and 4 metres in height will melt in one hour about
- In a gas turbine rotor a radial stress of 300 kg/sq cm tensile and 500 kg/sq cm tangential stress have been found at a point. The maximum shear stress at this point would be
- Minimum horsepower of pump required for filling 50m3 water tank, 20 metres high from ground in 30 minutes by lifting water from a well 5 metres below the ground level is
- What should be the thickness of a cast iron pipe 45 cm diameter if it is required to sustain 6 kg/sq cm inside pressure ? The maximum stress in the pipe material being limited to 140 kg/cm2
- The safe working pressure for a spherical vessel 1.5 m diameter and 1.5 cm wall thickness with limiting tensile stress of 450 kg/cm2 would be
- In case of biaxial stress system when a member is subjected to tensile stresses in two perpendicular directions the maximum shear stress in case of mild steel occurs on a plane inclined at
