Two rods A and B are subjectd to equal load P. Rod A is tapering with bigger diameter D at the support and small end diameter as D/2. Rod B is of uniform cross section with diameter D. The ratio of elongation of rod A to that of B would be

Strength Of Materials Mcqs
BILAL KHATTAK0

A.4
B.2
C.1

Related Mcqs:

  1. Two beams of equal cross-sectional area are subjected to equal bending moment. If one beam has square cross-section and the other has circular section, then
  2. An axial hoad is applied on a circular section of diameter D. If the same load is applied on hollow circular section with inner diameter D/2, the ratio of stress in two cases would be
  3. An axial load P is applied on a circular section of diameter D. If the same load is applied on a hollow circular shaft with inner diameter as D/2, the ratio of stress in two cases would be
  4. The area around the centre of gravity of a cross-section within which any load applied will produce stress of only one sign throughout the entire cross-section, is known as
  5. Two shafts are made of mild steel one having circular cross-section and the other shaft is hollow circular with inner diameter half of the outer diameter. The ratio of the torque that can be transmitted in two cases will be
  6. Two rods one of copper and the other of mild steel, both of diameter 20 mm and length 250 mm are coated with a uniform layer of wax all around. These rods are placed vertically in a boiling water bath with 200 mm, length of each rod projecting outside. If the melting point of wax is 10?C, then
  7. V belt having cross-section A is suitable for usual load of 5 HP. If 15 HP load is to be transmitted
  8. Two shafts of the same material are subjected to the same torque. If the first shaft is of solid circular section and the second shaft is of hollow section whose internal diameter is 2/3 of the outside diameter, the ratio of weights of hollow shaft to solid shaft would be
  9. Two steel shaft each of length L and outside diameter D are subjected to uniform torsion. The first shaft is solid while the second one is hollow with inside diameter D/2. The ratio of the strain energies that these two shafts can absorb without exceeding a maximum allowable shear stress, would be
  10. A prismatic steel bar 25 cm long is subjected to axial compressive force of 2000 kg. For steel E = 2 x 106 kg/cm2. The ratio of strain energy when the cross-sectional area is 25 sq. cm to that when the cross-section area is 12.5 sq cm, would be

Leave a Reply

Your email address will not be published. Required fields are marked *