A.1 mm
B.2 mm
C.3 mm
D.5 mm
E.6 mm
Related Mcqs:
- The pitch of threads on a lock-nut is
- A gear has a pitch diameter of 5.732 inches and circular pitch
- For a rational number for the pitch circle diameter and a rational number of teeth on the wheel, the circular pitch will work out to
- While designing for screw threads care should be taken to provide adequate length of engagement for the screw and nut threads so as to prevent failure of threads in
- A fine series screws of major diameter 8 mm and pitch 1 mm is generally designated as
- If screw threads are to be used in a situation involving high stresses in one direction only, the types of threads suitable for this would be
- If M 20 coarse pitch is 2.5 mm the mm the fine pitch for the size would be
- If the threads on a bolt are right hand the threads on nut will be
- A screw jack has 4 threads per inch. The mean radius of the thread is 2.338 inches. The mean diameter of the bearing surface under the cap is 3.25 inches. What is the turning moment required to raise the bload of 150 kg (
- Two rods A and B are subjectd to equal load P. Rod A is tapering with bigger diameter D at the support and small end diameter as D/2. Rod B is of uniform cross section with diameter D. The ratio of elongation of rod A to that of B would be
