A.0.4
B.0.8
C.1088
D.5.44
E.None of the above
Related Mcqs:
- A mercury-water manometer has a gage difference of 0.7 m (difference in elevation of menisci). The difference in pressure measured in metres of water is
- The pressure in millimetres of mercury gauge, equivalent to 68 mm H2O plus 54.4 mm manometer fluid, sp. Gr. 2.5 is
- In a mercury differential manometer used for measuring pressure differences across a venturimeter in a water pipeline if an error of 1 mm has been made in observing a differential head of 20 mmthe percentage error in pressure difference is
- The pressure of steam generated in a boiler as recorded by the Bourdon pressure gauge was 2.2 kg/sq-cm. If the barometer reads 774 mm of mercury the absolute pressure of steam would be
- If a steam pressure of 10 kg/cm2 is to be measured, the range of pressure gauge should be
- A gas used in gas engine trial was tested in a Boys Calorimeter. The pressure of gas supply was 7 cm of water column. If the barometric pressure is 760 mm of mercury, the absolute pressure of the gas would be
- The pressure in metres of oil (specific gravity 0.85) equivalent to 42.5 m of water is
- The temperature difference between water at the surface and the lower levels of the ocean (over a few handred metres) is about
- If the box in above problem is accelerated in a horizontal direction parallel to a pair of sides at the rate of 1 m/sec2, maximum pressure on the top of the box in metres of water would be
- Minimum horsepower of pump required for filling 50m3 water tank, 20 metres high from ground in 30 minutes by lifting water from a well 5 metres below the ground level is
