A.0.1 mm
B.1.0 mm
C.0.01 mm
D.None of these
Related Mcqs:
- Two rods A and B are subjectd to equal load P. Rod A is tapering with bigger diameter D at the support and small end diameter as D/2. Rod B is of uniform cross section with diameter D. The ratio of elongation of rod A to that of B would be
- The closed-coiled helical springs are made from the same small diameter wire, one wound on 2.5 cm diameter core and the other on 1.25 cm diameter core. If each spring has n coils, the ratio of their spring constants would be
- Estimation of movement ratios from average diameter growth by diameter classes is / are :
- The polar moment of inertia of a hollow circular section whose external diameter is 8 cm and internal diameter of 6 cm will be
- The moment of inertia of a hollow circular section whose external diameter is 8 cm and interial diameter is 6 cm about the axis passing through its centre is
- The polar diameter of the earth is shorter than equatorial diameter by about:
- In a pumping installation the suction line is is 4 metre long and suction pipe diameter is 100 mm. Now if the suction pipe is replaced by a pipe combination consisting of 2 metres of 100 mm diameter pipe joined with 2 metres of 150 mm diameter pipe, the suction heat will become
- A load of 10,000 kg is applied to copper cylinder 20 cm long and 5 cm in diameter causes the length to increase by 4 mm and diameter to decrease by 0.4 mm. The Poisson’s ratio for copper would be
- If this shaft is to be replaced by a hollow shaft of texternal diameter 22 mm for the same maximum shear stress and same torque, the internal diameter will be
- A turbine model test with 260 mm diameter showed an efficiency of 90 percent. The efficiency that can be expected from a 1.2 m diameter impeller is
