A.100 RPM
B.153 RPM
C.167 RPM
D.173 RPM
E.208 RPM
Related Mcqs:
- A turbine model test with 260 mm diameter showed an efficiency of 90 percent. The efficiency that can be expected from a 1.2 m diameter impeller is
- A circulating water pump of a condenser is of the centrifugal type and directly connected to a three phase induction motor running at 900 rpm. The pump delivers 30,000 litres per minute against the dynamic head of 10 m. The horse power of the motor required to drive the pump would be
- A seamless water main 1 metre in diameter is required to carry wter under a head of 100 metres. If the maximum permissible tensile stress in the metal is 500 kg/cm2, the thickness of metal required would be
- Total installed cost of a centrifugal pump coupled with drive and capable of developing 1000 ft head at 500 gpm is to be calculated using Rs. 55000 as the cost of a pump of 500 ft head at 1000 gpm. The cost estimation method involves the term capacity which will be taken as (gpm)x (head)y where
- The specific speed of a pump is defined as the speed of a pump
- If the specific speed of a pump is calculated as 5000, the type of pump that should be selected is
- If the specific speed of a pump is in the range 170 to 400, the type of pump would be
- Which type of pump is preferred for pumping lubricating oil in automobile
- A hydro-electric site has a head of 100 m and an average discharge of 10m3/s. Assume 92% efficiency, for a greater speed of 6000 rpm, the specific speed of turbine would be
- For pumping highly viscous fluid viscous, the type of pump enerally used is
