A.Rise on the front side of the tank
B.Fall on the front side of the tank
C.Rise on the back side of the tank and fall on front
D.Fall on the back side of the tank and rise on front
E.Front side fluctuate considerably
Related Mcqs:
- A U-tube of uniform cross-section is partially filled with a liquid A. Another liquid B which does not mix with liquid A is pour3ed into one side. It is found that the liquid levels of the two sides of the tube are the same. While the level of liquid A has risen by 2 cm. If the specifics gravity of liquid A is 1.1 the specific gravity of liquid B must be
- A small plastic boat loaded with pieces of steel rods is floating in a bath tub. It the cargo is dumped into the water allowing the boat to float empty, the water level in the tub will
- A tank 2 m square contains one metre of water. Now the tank is accelerated in the horizontal direction parallel to a pair of sides at the rate of 4 m/sec2. In order that there may be no spilling of water the minimum height of the tank should be
- What is the difference between a lake and a tank?
- A horizontal load of 120 kg/mt is to be carried by a cable suspended between supports at same level and 60 mts apart. If the maximum permissible tension is 36,000 kg the required length of cable is
- Minimum horsepower of pump required for filling 50m3 water tank, 20 metres high from ground in 30 minutes by lifting water from a well 5 metres below the ground level is
- The bedroom is at the rear side of this house.
- A right circular cylinder open at the top is filled with liquid (specific gravity 1.2) and rotated about its vertical axis at such speed that half the liquid spills out. The pressure at centre of the bottom is
- A 500 litre tank contains a saturated mixture of steam and water at 300?C. If the mass of steam and water within the tank is equal, it can be concluded that
- A closed cubical box 0.8 m on each side is half filled with water and the other half being filled with oil of specific gravity 0.75. Now if the box is accelerated upwards at the rate of 4.905 m/sec2 the pressure difference in kg/m2 between the top and bottom layers would be
