A.6 N/mm2
B.12 N/mm2
C.18 N/mm2
D.20 N/mm2
E.24 N/mm2
Related Mcqs:
- A short, hollow cast iron cylinder with a wall thickness of 1 cm is to carry a compressive load of 10 tonnes. If the working stress in compression is 800 kg/cm2, the outside diameter of the cylinder should not be less than
- For a thin longitudinal cylinder the ratio hoop stress/longitudinal stress is
- A spring steel ribbon 3.2 mm wide, 0.5 mm thick is wound on a 500 mm diameter cylinder. If E = 2 x 105 N/mm2, the maximum stress in the steel will be
- In case of thin walled cylinders the ratio of hoop stress to maximum shear stress stress is
- A thin cylinder contains fluid at a pressure of 30 kg/cm2, the inside diameter of the shell is 60 cm and the tensile stress in the material is to be limited to 900 kg/cm2. The shell must have minimum wall thickness of
- A thin cylinder contains fluid at a pressure of 30 kg kg/cm2, the internal diameter of the shell is 60 cm and the tensile stress in the material is to be limited to 900 kg/cm2. The shell must have a minimum wall thickness of
- In a gas turbine rotor a radial stress of 300 kg/sq cm tensile and 500 kg/sq cm tangential stress have been found at a point. The maximum shear stress at this point would be
- The safe value of stress under which a member subjected to reversible tensile or compressive stress will not fail is known as
- In case of thin walled cylinders the ratio of hoop stress to radial stress is
- In case of thin walled cylinders the ratio of longitudinal stress to shear stress is
