A.1
B.2
C.4
D.8
Related Mcqs:
- For punching a hole of 25 mm diameter in a plate 20 mm thick, if the shear stress of plate material is 30 kg/mm2, the force required would be
- A jet of water of cross-sectional area 20 sq. cm impinges on a plate at an angle of 60? with a velocity of 10 m/sec. Neglecting the friction between the jet and plate (density of water 1000/9.81 kgm-1 sec2 per cubic meter), the force exerted by the jet on the plate would be in the range
- Which device is required for the Internet connection??
- A plate 0.6 mm distant from a fixed plate moves at 0.24 m/s and requires a force per unit area of 1 N/m2 to maintain this speed. Thefluid viscosity of the substance between the plates in N.s/m2 is
- The minimum age required to become a member of Rajya Sabha is __________?
- Force on a flat stationary plate is
- It is desired to punch a hole of 20 mm diameter in a plate 20 mm think. If the shear stress of mild steel is 30 kg/mm2, the force necessary for punching would be approximately in the range
- A prismatic steel bar 25 cm long is subjected to axial compressive force of 2000 kg. For steel E = 2 x 106 kg/cm2. The ratio of strain energy when the cross-sectional area is 25 sq. cm to that when the cross-section area is 12.5 sq cm, would be
- A sheet metal 2 mm thick having a shear strength of 40 kg/cm2 is to receive a punch hole of 35 mm diameter. The force required to make the punching will be
- The horizontal force required to slide the tail stock would be
