A.1250 m
B.1750 m
C.2500 m
D.2797 m
E.3155 m
Related Mcqs:
- If the allowable shear stress is 960 kg/sq. cm for the size h cm, the allowable force per cm of weld length would be
- Two plates are joined by a parallel fillet welds. The plates are subjected to a tensile load of 35000 kg. If the allowable shear stress for the weld material be 800 kg the minimum length of 15 mm weld required to resist this load would be
- Two steel shaft each of length L and outside diameter D are subjected to uniform torsion. The first shaft is solid while the second one is hollow with inside diameter D/2. The ratio of the strain energies that these two shafts can absorb without exceeding a maximum allowable shear stress, would be
- The approximate value of allowable stress for carbon steel under static loading (in kg/cm2) is:
- A uniform steel rope 400 metres long is hung vertically. The weight of the steel is 7.8 gm/cm3 and D = 2100 kg/mm2. The ratio of elongation of first 150 metres to that of first 300 metres would be
- Two rods one of copper and the other of mild steel, both of diameter 20 mm and length 250 mm are coated with a uniform layer of wax all around. These rods are placed vertically in a boiling water bath with 200 mm, length of each rod projecting outside. If the melting point of wax is 10?C, then
- The approximate value of allowable stress for carbon steel under static loading (in kg/cm2) is
- In case of biaxial stress system when a member is subjected to tensile stresses in two perpendicular directions the maximum shear stress in case of mild steel occurs on a plane inclined at
- Copper wire of certain length and resistance is drawn out to three times its length without change in volume, the new resistance of wire becomes __________?
- The safe value of stress under which a member subjected to reversible tensile or compressive stress will not fail is known as
