A.0.5 cm
B.1.0 cm
C.2.5 cm
D.4.5 cm
E.5 cm
Related Mcqs:
- The safe working pressure for a spherical vessel 1.5 m diameter and 1.5 cm wall thickness with limiting tensile stress of 450 kg/cm2 would be
- A thin cylinder contains fluid at a pressure of 30 kg/cm2, the inside diameter of the shell is 60 cm and the tensile stress in the material is to be limited to 900 kg/cm2. The shell must have minimum wall thickness of
- A thin cylinder contains fluid at a pressure of 30 kg kg/cm2, the internal diameter of the shell is 60 cm and the tensile stress in the material is to be limited to 900 kg/cm2. The shell must have a minimum wall thickness of
- What should be the thickness of a cast iron pipe 45 cm diameter if it is required to sustain 6 kg/sq cm inside pressure ? The maximum stress in the pipe material being limited to 140 kg/cm2
- An axial load P is applied on a circular section of diameter D. If the same load is applied on a hollow circular shaft with inner diameter as D/2, the ratio of stress in two cases would be
- A bolt of nominal diameter 33 mm having a safe tensile stress of 100 N/mm2 can safely carry a load of
- An axial hoad is applied on a circular section of diameter D. If the same load is applied on hollow circular section with inner diameter D/2, the ratio of stress in two cases would be
- A seamless water main 1 metre in diameter is required to carry wter under a head of 100 metres. If the maximum permissible tensile stress in the metal is 500 kg/cm2, the thickness of metal required would be
- A compressed air cylinder carries approximately 70 kg/cm2 pressure at the time of delivery. The inside diameter is 25 cm. If the steel has a yield point of 2300 kg/sq cm and a safety factor of 2.5 the wall thickness should be
- If this shaft is to be replaced by a hollow shaft of texternal diameter 22 mm for the same maximum shear stress and same torque, the internal diameter will be
