In a turret lathe a pre-selector is a device

Production Engineering Mcqs
BILAL KHATTAK0

A.That is used to select in the job prior to loading
B.That is used to decide the operation to be done on a job prior to a specific operation
C.That is used to pre-select the spindle speed for the next operation in progress
D.Used for feeding bar to chuck
E.None of above

Related Mcqs:

  1. The size of a lathe is expressed by
  2. While machining a brass casting on a lathe, the type of chuck used is
  3. When large number of components are turned and parted off from a bar, the chuck used is
  4. Which of the following is dimensionless?
  5. If the rake angle on a HSS lathe tool is 25 degrees the materials being machined is
  6. While using HSS tools on a lathe, cutting speed will be maximum when machining
  7. Under which condition a material ordinatily said to be ductile undergoes a fracture similar to that of a brittle material
  8. Working medium for closed cycle gas turbine should have
  9. If engines of different horse power, rpm, cylinder dimensions are to be compared for their performance, the parameter of comparison could be
  10. which one is Digital device, select from the choices below??

Leave a Reply

Your email address will not be published. Required fields are marked *