A mandrel is

Production Engineering Mcqs
BILAL KHATTAK0

A.A slightly tapered hardened steel shaft that supports works which cannot be supported otherwise
B.A tapered gauge used for inspection of tapered holes
C.Auxiliary chuck used on lathe for holding small loads
D.Is used in lathe work to hold castings
E.None of above

Related Mcqs:

  1. The size of a lathe is expressed by
  2. Marform is
  3. Warping may be avoided when quenching a long slender piece of work by
  4. A continuous beam is one which is
  5. Angle plate is
  6. While machining a brass casting on a lathe, the type of chuck used is
  7. When large number of components are turned and parted off from a bar, the chuck used is
  8. If ash content of coke used in cupola is high then
  9. Taper shank on drills is provided for
  10. If an old casting is to be used as a pattern, to account for various allowances.

Leave a Reply

Your email address will not be published. Required fields are marked *