A.0.45 m/s
B.1 m/s
C.2.5 m/s
D.9.8 m/s
Related Mcqs:
- The normal capacity of a one metre escalator is around
- Failure of an engine to start even though it turns over at normal cranking speed could be due to
- While using high speed steel tools on lathe the speed of chuck will be lowest while machining
- Spindle speed in a lathe for turning a 40 cm dia rod at a cutting speed of 30 m/min would be
- A hydro-electric site has a head of 100 m and an average discharge of 10m3/s. Assume 92% efficiency, for a greater speed of 6000 rpm, the specific speed of turbine would be
- If ? is the angle between an incident beam of flux Ibn and the normal to a plane surface then the equivalent flux falling normal to the surface is
- The speed range of medium speed engine is:
- In a lathe gear box if first four consecutive speed are 19, 30, 47, 74 rpm, the next speed would be
- When 50 mm rod is turning at a spindle speed of 200 rpm the cutting speed would be
- An engine operates at 1440 rpm under load whereas no load speed is 1500 rpm. The percentage speed drop of governor will be
