While designing a shaft pulley and key for a system

Machine Design Mcqs
BILAL KHATTAK0

A.Shaft is the weakest member
B.Pulley is the weakest member
C.Key is the weakest member
D.All are designed for equal strength
E.None of the above

Related Mcqs:

  1. In design of a shaft, pulley and key for a system
  2. While designing a shaft, hub and a key, care is taken so that
  3. In order that a belt may not run off the pulley
  4. The ‘crowning’ of flat pulleys is generally done pulley
  5. The critical speed of a shaft is affected by
  6. In case of a Saddle key
  7. Each member of the academy was given a prize.
  8. The secondary critical speed of a shaft occurs at
  9. Two shafts of the same material are subjected to the same torque. If the first shaft is of solid circular section and the second shaft is of hollow section whose internal diameter is 2/3 of the outside diameter, the ratio of weights of hollow shaft to solid shaft would be
  10. In case of sunk key

Leave a Reply

Your email address will not be published. Required fields are marked *