While designing a shaft, hub and a key, care is taken so that

Machine Design Mcqs
BILAL KHATTAK0

A.Shaft is the stronger component
B.Hub is the strongest component
C.Key is the strongest component
D.Key is the weakest component
E.Shaft is the weakest component

Related Mcqs:

  1. While designing a shaft pulley and key for a system
  2. In design of a shaft, pulley and key for a system
  3. While designing for screw threads care should be taken to provide adequate length of engagement for the screw and nut threads so as to prevent failure of threads in
  4. The critical speed of a shaft is affected by
  5. In case of a Saddle key
  6. Which of the following component of attitude represents a person’s opinio’ns knowledge, and information??
  7. The secondary critical speed of a shaft occurs at
  8. Two shafts of the same material are subjected to the same torque. If the first shaft is of solid circular section and the second shaft is of hollow section whose internal diameter is 2/3 of the outside diameter, the ratio of weights of hollow shaft to solid shaft would be
  9. Heavy vacuum gas oil obtained from vacuum distillation unit is mainly used as
  10. In case of sunk key

Leave a Reply

Your email address will not be published. Required fields are marked *