A.Compression
B.Tension
C.Shear
D.Torque
E.Biaxial stress
Related Mcqs:
- When a nut is tightened by placing a washer below it, the bolt will be subjected to
- While designing for screw threads care should be taken to provide adequate length of engagement for the screw and nut threads so as to prevent failure of threads in
- Eccentrically loaded columns are generally subjected to
- In a ball bearing a ball is subjected to
- Two beams of equal cross-sectional area are subjected to equal bending moment. If one beam has square cross-section and the other has circular section, then
- The rollers of a cycle chain are subjected to
- Notches in a section produce
- Along the principal plane subjected to maximum principal shear
- Two rods A and B are subjectd to equal load P. Rod A is tapering with bigger diameter D at the support and small end diameter as D/2. Rod B is of uniform cross section with diameter D. The ratio of elongation of rod A to that of B would be
- In case of a knuckle joint the pin is likely to fail in
