The basic shaft is

Machine Design Mcqs
BILAL KHATTAK0

A.One which has no upper deviation
B.One which has no lower deviation
C.One which has least deviation on both upper and lower side
D.Does not exist
E.None of the above

Related Mcqs:

  1. The basic hole is one which has
  2. If a rectangular shaft is subjected to torsion, the maximum sher stress will occur
  3. The bedroom is at the rear side of this house.
  4. In normalising steel is heated 40-50 C
  5. Belching is expelling of air swallowed from:
  6. Side effect of heavy and constant grazing is that the:
  7. Two shafts of the same material are subjected to the same torque. If the first shaft is of solid circular section and the second shaft is of hollow section whose internal diameter is 2/3 of the outside diameter, the ratio of weights of hollow shaft to solid shaft would be
  8. A solid shaft of 100 mm diameter transmits 100 HP at (450/?) r.p.m. The torque in kg-m on the shaft would be
  9. The piston pin of some engine is offset to:
  10. The entrance point of sperm in frog’s egg marks which of the sides of future embryo:

Leave a Reply

Your email address will not be published. Required fields are marked *