A V-belt designated as C 120 will have

Machine Design Mcqs
BILAL KHATTAK0

A.120 mm as the dia of small pulley
B.120 cm as the length of belt
C.120 inch as the length of belt
D.120 cm as the centre distance between pulleys
E.None of the above

Related Mcqs:

  1. The stretching in a belt is controlled by
  2. In order that a belt may not run off the pulley
  3. A V belt designated as C 3048/120 will have
  4. Slip in belt drive is
  5. In case of Vee belt
  6. In case of flat belt drive the length of belt in case of
  7. Belt slip may occur due to
  8. The ‘crowning’ of flat pulleys is generally done
  9. The voltage required for good desalting of curde petroleum is approximately
  10. The ‘crowning’ of flat pulleys is generally done pulley

Leave a Reply

Your email address will not be published. Required fields are marked *