A.Floor rummer
B.Peen rammer
C.Hand rammer
Related Mcqs:
- Rammer used for moulding the sand in large mould known as
- The sand used for sprinkling on the patterns/parting surface of the mould is known as
- The hardness of the mould is affected by the proportion of ingredients in the sand and
- Sand grains which give high mould strength are
- The tool used to make small holes in the sand mould to allow passage of gases/steam is known as
- The moulding tool used for finishing/repairing the sand mould after pattern withdrawal is termed as
- For producing several similar parts from a single mould the moulding used is
- The sand used for filling the bulk of the moulding flask
- The defect known as ‘drop’ occurs when the upper surface of the mould cracks and pieces of sand fall into the molten metal. This defect occurs due to
- If the threads on a bolt are right hand the threads on nut will be
