In transmission system if the reverse gear slips out, the probable cause could be

Automobile Engineering Mcqs
BILAL KHATTAK0

A.Reverse sliding gear teeth worn out
B.Main shaft spines worn
C.Reverse idler gear teeth worn
D.Insufficient gear mesh
E.Any of the above

Related Mcqs:

  1. A standard gear cutter No. 3 is marked to cut 35-54 teeth. It implies that
  2. In case the clutch of a tractor slips, the probable cause cannot be
  3. A reverted gear train is one is which
  4. In a car transmission losses will be least in which gear?
  5. A reverted gear train is one in which
  6. Which one of the following is mounted between the engine and gear box?
  7. A gear cutter suitable for cutting 42 to 54 teeth will provide correct form
  8. A gear used in timing gear is:
  9. In the gear box of an automobile, which gear train is used?
  10. For speed reduction in the ratio of 100 the type of gear preferred is

Leave a Reply

Your email address will not be published. Required fields are marked *