A.Shell side
B.Tube side
C.Either of (A) and (B) above
D.None of the above
Related Mcqs:
- A 1-2 heat exchanger means
- In a shell and tube heat exchanger the baffles are used
- A liquid to liquid counterflow heat exchanger is used to heat cold fluid from 50?C to 150?C. Assuming that the hot fluid enters at 250?C and leaves at 200?C, the log mean temperature difference for the heat exchanger will be closer to
- Which of the following temperature measuring devices is widely used measure tube side temperature in a shell and tube heat exchanger?
- A liquid flowing through a tube is turbulent. In which case will the maximum change in heat transfer coefficient occur?
- A U-tube of uniform cross-section is partially filled with a liquid A. Another liquid B which does not mix with liquid A is pour3ed into one side. It is found that the liquid levels of the two sides of the tube are the same. While the level of liquid A has risen by 2 cm. If the specifics gravity of liquid A is 1.1 the specific gravity of liquid B must be
- Shell moulding is a process in which
- A liquid is boiling in a a air tight vessel. Using an exhaust tube, the vapour is pumped out at a faster rate. What happens to the liquid?
- In case of thin cylindrical shell with hemispherical ends
- A heat exchanger that can remove fixed quantity of heat from a system is available where should it be installed for best economy
