A.1
B.1?2
C.1?4
D.1?8
E.1?16
Related Mcqs:
- A composite spring is made by joining two springs end to end one spring having twice the stiffness of the other. The ratio of the stiffness of the composite spring to that of the stiffness of the two springs could be
- A spring steel ribbon 3.2 mm wide, 0.5 mm thick is wound on a 500 mm diameter cylinder. If E = 2 x 105 N/mm2, the maximum stress in the steel will be
- The deflection of a helical spring is
- A wound watch spring possesses energy in the form of
- The extension and compression of a helical spring is an example of
- Two rods A and B are subjectd to equal load P. Rod A is tapering with bigger diameter D at the support and small end diameter as D/2. Rod B is of uniform cross section with diameter D. The ratio of elongation of rod A to that of B would be
- The resistance of a few meters of wire conductor in closed electrical circuit is __________?
- A load of 10,000 kg is applied to copper cylinder 20 cm long and 5 cm in diameter causes the length to increase by 4 mm and diameter to decrease by 0.4 mm. The Poisson’s ratio for copper would be
- Two shafts are made of mild steel one having circular cross-section and the other shaft is hollow circular with inner diameter half of the outer diameter. The ratio of the torque that can be transmitted in two cases will be
- A block of weight 20 kg slides with an initial velocity of 2 m sec down an inclined plane on to a spring of stiffness 10 kg/cm. If the co–efficient of friction is 0.2, angle ? = 30 the ratio of maximum compession of spring, neglecting friction to that while considering friction would be
