A.25
B.100
C.314
D.628
Related Mcqs:
- A grinding wheel rotates at 3000 rpm. When power supply is cut off the wheel stops in 5 sec. The number of revolutions made by the wheel before coming to rest would be
- A grinding wheel rotates at 3000 rpm. When power supply is cut-off the wheel stops in 10 seconds. The number of revolutions made by the wheel before coming to rest would be
- A couple applied to a flywheel of mass 5 kg and of radius of gyration 20 cm produces an angular acceleration of 4 radians/sec2. The torque applied in dyne cm is
- A wheel accelerates from rest with an acceleration of 6 rad/sec2. How many revolutions are experienced in 4 seconds?
- A grinding wheel is rotating at 3000 rpm. When the switch is turned off the wheel stops in 10 seconds. The uniform deceleration of the wheel was
- A uniform steel rope 400 metres long is hung vertically. The weight of the steel is 7.8 gm/cm3 and D = 2100 kg/mm2. The ratio of elongation of first 150 metres to that of first 300 metres would be
- In a single threaded worm and worm wheel the number of teeth on the worm wheel is 60. The diameter of the effort wheel is 12 cm and that of load drum is 8 cm. The velocity ratio will be
- In a single threaded worm and worm wheel the number of teeth on the worm wheel is 80. The diameter of the effort wheel is 12 cm and that of load drum is 8 cm. The velocity ratio will be
- The number of revolutions per km for a free rolling tyre are less than that calculated from its static radius. This difference in number of revolutions is due to
- Minimum horsepower of pump required for filling 50m3 water tank, 20 metres high from ground in 30 minutes by lifting water from a well 5 metres below the ground level is
