A.r = 2 cm, l = 2m
B.r = 1 cm, l = 1m
C.r = 2 cm, l =
D.r =
Related Mcqs:
- Two rods one of copper and the other of mild steel, both of diameter 20 mm and length 250 mm are coated with a uniform layer of wax all around. These rods are placed vertically in a boiling water bath with 200 mm, length of each rod projecting outside. If the melting point of wax is 10?C, then
- There are two spheres of copper the ratio of their radii being 1 : 3 both at the same temperature. The ration of heat contents will be
- Three rods one made of glass, one of pure aluminium and one made of wrought iron are heated to 150?C. All the rods are 15 mm in diameter and 300 mm long. The lowest temperature at the free end of the rods will occur in case of
- A heat engine works on a Carnot cycle with a heat sink at a temperature of 27?C. The efficiency of the engine is 10%, the temperature of the heat source is
- A dimensionless heat transfer coefficient which gives a measure of the ratio of the heat transfer rate to the rate at which heat would be conducted within the fluid under a temperature gradient is known as
- The ratio of heat transfer coefficient to the flow of heat per unit temperature rise due to the velocity of the fluid is known as
- A liquid to liquid counterflow heat exchanger is used to heat cold fluid from 50?C to 150?C. Assuming that the hot fluid enters at 250?C and leaves at 200?C, the log mean temperature difference for the heat exchanger will be closer to
- Two parallel opposed, infinite black planes are maintained at 300?C and 400?C respectively. If the temperature difference is doubled by increasing the temperature from 400?C to 500?C, the heat exchange rate will increase by a factor of about
- A dimensionless number which is the ratio of mass heat flow rate to the heat flow rate by conduction under a unit temperature gradient and through a thickness L is known as
- At Rs. X per kWh how much will it cost to maintain a temperature of 35?C for 24 hours in a box 0.5 m square on each side if the outside temperature is 20?C and the overall heat transfer coefficient for the box is 0.6 W/(m2 K)
