A.Shell side
B.Tube side
C.Either of (A) and (B) above
D.None of the above
Related Mcqs:
- A 1-2 heat exchanger means
- A U-tube of uniform cross-section is partially filled with a liquid A. Another liquid B which does not mix with liquid A is pour3ed into one side. It is found that the liquid levels of the two sides of the tube are the same. While the level of liquid A has risen by 2 cm. If the specifics gravity of liquid A is 1.1 the specific gravity of liquid B must be
- A liquid to liquid counterflow heat exchanger is used to heat cold fluid from 50?C to 150?C. Assuming that the hot fluid enters at 250?C and leaves at 200?C, the log mean temperature difference for the heat exchanger will be closer to
- A liquid flowing through a tube is turbulent. In which case will the maximum change in heat transfer coefficient occur?
- In case of thin cylindrical shell with hemispherical ends
- If a water tank partially filled with water is being carried on a truck with a constant horizontal acceleration, the level of liquid will
- Isolate the factor on which bursting pressure of boiler does not depend
- Which of the following temperature measuring devices is widely used measure tube side temperature in a shell and tube heat exchanger?
- In a shell and tube heat exchanger the baffles are used
- Normally, in the process of osmosis, the net flow of water molecules into or out of the cell depends upon differences in the ??
