A.The equilibrium ball radii is constant for a given speed
B.For each speed within the working range the ball weights occupy a definite specific position
C.There is only one radius of the governor weights for each equilibrium sped
D.There is only one equibilbrium speed which is constant for all radii of rotation of the bells within the working range
E.None of the above
A.Involved
B.Not involved
C.Sometimes involved
D.Involved if some other conditions are satisfied
E.Involved but generally neglected
A.One that reciprocates in the guides
B.One that oscillates
C.One in which the follower translates along an axis passing through the cam centre of rotation
D.One in which the axis of the following movement is displaced from the cam centre
E.None of the above
A.The mechanical advantage will be high
B.The load will be sustained in absence of effort
C.The mechanical advantage will be low
D.The load will be easily lifted
E.While unloading, little effort will be required
A.Approximately 120 inch inside length
B.Approximately 120 cm inside length
C.C section, length unspecified
D.Width 120 mm
E.None of the above
A.Standard gear tooth
B.Equivalent rack tooth
C.Longer than standard tooth depth
D.Shorter than standard tooth depth
E.Non-standard tooth
A.Two links and two turning pairs
B.Three links and two turning pairs
C.Four links and two turning pairs
D.Four links and four turning pairs
E.Four links and five turning pairs
A.Turning pair only
B.Rotary pair only
C.Sliding and turning pairs
D.Turning and rotary pairs
E.Sliding and rotary pairs
A.Wood paving
B.Macadam
C.Well rolled gravel
D.Loose sand
