A.Localised machining of a component
B.Machining of a spot to fit other parts
C.Mahining of spol on the surface of a part to furnish a flat bearing or the head of a holt or nut
D.A spot prepared on shaper or milling machine
E.None of above
A.Ductile material
B.Brittle material
C.Cast materials
D.Hard materials
E.Non-ferrous materials
A.One that is automatically controlled
B.One that gives maximum production
C.One that gives high operating efficiency
D.One that gives good results
E.One that has minimum deviation following a disturbance
A.Large
B.Same as in other methods of casting
C.Small
D.Very small
E.Generally not provided
A.A pair of steel legs joined by a screw and nut
B.A steel bar and two sliding legs which can be adjusted
C.A divider with a spring
D.None of the above
A.The width of depression
B.The depth of depression
C.Diameter of depression
D.None of the above
A.Cement
B.Paper
C.Wood
D.Rubber
E.Glass
A.In which the length of valve is more than 10 times the width
B.In which the longest parameter of valve is not less than 20 times the widest part of the valve
C.In which the valve steam operates linearly
D.One in which the flow is directly proportional to the valve lift
E.None of the above
A.Tool
B.Chip
C.Coolant
D.Work piece
E.Depends on velocity of cutting
