In case of locomotion, the coefficient of adhesion is highest when
A.the rails are dry
B.the rails are oiled
C.the rails are wet
D.the rails are dusty
A.the rails are dry
B.the rails are oiled
C.the rails are wet
D.the rails are dusty
A.The point of intersection of the buoyant force and the centre line of the body
B.Centre of gravity of the body
C.Centroid of displaced volume of fluid
D.Mid-point between C.G. and metacentre
A.Same as maximum operating speed
B.Same as run away speed
C.The speed at which shaft will break
D.The speed at which the number of natural vibrations or natural frequency equals the number of revolutions per minute
E.The speed equal to synchronous speed of generator
A.14 holes in 21 hole circle plate
B.6 turns
C.26 holes in 21 hole circle plate
D.6 turns and holes in 21 hole circle plate
E.6 turns and 14 holes in 30 hole circle plate
A.flow of material
B.worker’s activity
C.minimizing delay
D.none of the above
A.2
C.4
E.None of the above
A.Taking over, by the government, of existing privately run concerns
B.Establishing new enterprises as state run concerns
C.Putting the day-to-day control of firms in the hands of Parliament
D.Instituting worker in control of an industry
E.The state assuming control of an industry to secure greater efficiency
A.Less than 0.01 mg/litre
B.Around 1 mg/litre
C.Around 5 mg/litre
D.Between 10 to 20 mg/litre
E.More than 50 mg/litre
A.slowly cooling in the martensitic range
B.using surface hardening when possible
C.using alloy steels least prone to such changes
D.Any of the above
A.Viscosity of liquid
B.Cohesion of liquid particles
C.Surface tension
D.Adhesion of liquid particles on the surface
E.None of the above