According to the law of gearing

Theory of Machines Mcqs
BILAL KHATTAK0

A.Common normal at the point of contact always passes through a fixed point (pitch point) on the line joining the centres of rotation
B.Teeth should be involute type
C.Teeth should be cycloidal type
D.Clearance should be minimum 0.15 mm
E.The gears whould be cut with the cutter having same module

Related Mcqs:

  1. A standard gear cutter No. 3 is marked to cut 35-54 teeth. It implies that
  2. In case of gears the pressure angle is
  3. Miter gears are
  4. In case of gears, the interference takes place
  5. The backlash between gears is expressed in terms of
  6. The advantages of involute profile over cycloidal are given below. Identify if there is any incorrect statement
  7. In climb milling
  8. Velocity of sliding between two mating gear surfaces can be defined as
  9. Which one of the following is not applicable to involute profile
  10. Coriolis component of acceleration will exist only if

Leave a Reply

Your email address will not be published. Required fields are marked *