A standard gear cutter No. 3 is marked to cut 35-54 teeth. It implies that

Theory of Machines Mcqs
BILAL KHATTAK0

A.The cutter is to be replaced after cutting 54 teeth
B.The cutter will be suitable for gears having 35 to 54 teeth
C.The cutter will be suitable for spur gear teeth cutting only
D.The cutter will provide correct profile for any gear having number of teeth in the range 35 to 54
E.None of the above

Related Mcqs:

  1. A gear cutter suitable for cutting 42 to 54 teeth will provide correct form
  2. What type of gears are provided in a switch gear?
  3. In case of gears, the interference takes place
  4. If two gears having 24 and 96 teeth mesh each other, they must have been cut
  5. Which of following gear system have minimum axial thrust?
  6. Miter gears are
  7. A gear used in timing gear is:
  8. For speed reduction in the ratio of 100 the type of gear preferred is
  9. The backlash between gears is expressed in terms of
  10. The teeth on the crankshaft gear is:

Leave a Reply

Your email address will not be published. Required fields are marked *