A.1600 N/mm2
B.1200 N/mm2
C.800 N/mm2
D.400 N/mm2
Related Mcqs:
- A spring steel ribbon 3.2 mm wide, 0.5 mm thick is wound on a 500 mm diameter cylinder. If E = 2 x 105 N/mm2, the maximum stress in the steel will be
- A rectangular beam 200 mm deep by 100 mm wide-subjected to maximum bending moment of 500 kNm. The maximum stress in the beam will be
- Two shafts are made of mild steel one having circular cross-section and the other shaft is hollow circular with inner diameter half of the outer diameter. The ratio of the torque that can be transmitted in two cases will be
- Two steel shaft each of length L and outside diameter D are subjected to uniform torsion. The first shaft is solid while the second one is hollow with inside diameter D/2. The ratio of the strain energies that these two shafts can absorb without exceeding a maximum allowable shear stress, would be
- An axial hoad is applied on a circular section of diameter D. If the same load is applied on hollow circular section with inner diameter D/2, the ratio of stress in two cases would be
- An axial load P is applied on a circular section of diameter D. If the same load is applied on a hollow circular shaft with inner diameter as D/2, the ratio of stress in two cases would be
- A steel shaft 6 mm in diameter turns at 10,000 r.p.m. the safe working stress in shear is 350 kg/cm2. The maximum power that such a shaft may develop is approximately
- With a punch for which the maximum crushing stress is 4 times the maximum shearing stress of the plate, the biggest hole that can be punched in the plate would be of diameter equal to
- A solid circular shaft and a thin walled circular tube made of the same material and having the same weight are stressed in torsion to the same maximum shear stress. The ratio of the amounts of strain energy stored in the two shafts would be
- The ratio of maximum shear stress to average shear stress in case of a circular beam transmitting power is equal to
