A.1 cm to 2 cm
B.2 cm to 3 cm
C.3 cm to 4 cm
D.4 cm to 5 cm
E.7 cm to 9.7 cm
Related Mcqs:
- A steel shaft 6 mm in diameter turns at 10,000 r.p.m. the safe working stress in shear is 350 kg/cm2. The maximum power that such a shaft may develop is approximately
- Approximate horse power that can be transmitted by a shaft 60 mm diameter at 180 r.p.m. with permissible shear stress of 850 kg/cm2, would be
- Approximate horse power that can be transmitted by a shaft 60 mm dimeter at 180 rpm with permissible shear stress of 850 kg/cm2 would be
- If this shaft is to be replaced by a hollow shaft of texternal diameter 22 mm for the same maximum shear stress and same torque, the internal diameter will be
- Two steel shaft each of length L and outside diameter D are subjected to uniform torsion. The first shaft is solid while the second one is hollow with inside diameter D/2. The ratio of the strain energies that these two shafts can absorb without exceeding a maximum allowable shear stress, would be
- It is desired to punch a hole of 20 mm diameter in a plate 20 mm think. If the shear stress of mild steel is 30 kg/mm2, the force necessary for punching would be approximately in the range
- The ratio of maximum shear stress to average shear stress in case of a circular beam transmitting power is equal to
- For punching a hole of 25 mm diameter in a plate 20 mm thick, if the shear stress of plate material is 30 kg/mm2, the force required would be
- The adiabatic horse power required to deliver 4 cu. M per minute of free air from 1 ata and 15?C to a received pressure at 7 ata would be in the range
- In case of a circular shaft subjected to torque the value of shear stress
