In a sine bar the standard length is measured from

Production Engineering Mcqs
BILAL KHATTAK0

A.Edge to edge
B.Between inner circumference of two buttons
C.Between out circumference of two buttons
D.Between the centers of two buttons
E.Any of the above

Related Mcqs:

  1. What is place to the left of horizontal scroll bar??
  2. For defining length the standard generally followed is
  3. The length of a hacksaw blade is measured from
  4. Which of the following standard can be used for defining length?
  5. Polar circumference of the earth is:
  6. If we were studying a sample of 100 students and their examination performance and if the standard deviation of the list of results was say 14, then we could calculated the standard error by ___________??
  7. The statement —- if three forces acting at a point are in equilibrium, each force is proportional to the sine of the angle between the other two —- is known as
  8. If a drill has different lengths of cutting edges
  9. A column has its equivalent length equal to its length in case of
  10. What is the Continental Shelf?

Leave a Reply

Your email address will not be published. Required fields are marked *