A gate is the

Production Engineering Mcqs
BILAL KHATTAK0

A.Passage through which metal is poured into the mould
B.Passage through which metal rises when the mould is filled
C.Passage that finally leads molten metal from the runner into the mould cavity
D.Vent hole to allow for the hot gases to escape
E.Channel for the flow of excess molten material

Related Mcqs:

  1. The function of riser is
  2. The design of gate should be such as to
  3. Which of the following statement about core is incorrect?
  4. The pouring of molten metal during casting should be stopped when
  5. A sprue is
  6. In die casting
  7. Swell is a defect in castings due to
  8. Steam trap is a device that
  9. Core prints are provided to
  10. In drilling operation if the drill point is outside the drill axis, the effect on the drilled hole will be

Leave a Reply

Your email address will not be published. Required fields are marked *