While designing for screw threads care should be taken to provide adequate length of engagement for the screw and nut threads so as to prevent failure of threads in

Machine Design Mcqs
BILAL KHATTAK2

A.Tension
B.Compression
C.Torque
D.Shear
E.None of the above

Related Mcqs:

  1. The minor-diameter cross-section of the portion of the screw between the nut and the thrust bearing is subjected to
  2. When a nut is tightened by placing a washer below it, the bolt will be subjected to
  3. In case of a knuckle joint the pin is likely to fail in
  4. If screw threads are to be used in a situation involving high stresses in one direction only, the types of threads suitable for this would be
  5. The loading on a pinion gear is usually
  6. While designing a shaft, hub and a key, care is taken so that
  7. The cemented carbide tools are generally poor in
  8. The efficiency of a riveted joint is defined as the ratio of actual strength of the joint to that of solid plate. In this strength of the joint is considered in
  9. Eccentrically loaded columns are generally subjected to
  10. The maximum efficiency of a screw jack provided with square threads and angle of friction 30? will be

2 thoughts on “While designing for screw threads care should be taken to provide adequate length of engagement for the screw and nut threads so as to prevent failure of threads in”

Leave a Reply

Your email address will not be published. Required fields are marked *