In a cotter joint in order to ensure that cotter does not work back

Machine Design Mcqs
BILAL KHATTAK0

A.Shear pins should be applied on the cotter
B.Cotter should be made thick
C.Cotter should be made of stronger material
D.The taper on cotter should not exceed 1 in 24
E.The taper on cotter should be more than 1 in 24

Related Mcqs:

  1. In case of a cotter joint the compressive load is transmitted from one rod to another rod
  2. The efficiency of a riveted joint is defined as the ratio of actual strength of the joint to that of solid plate. In this strength of the joint is considered in
  3. In case of a knuckle joint the pin is likely to fail in
  4. Shanks of taper drills are provided standard taper known as
  5. Standard taper generally used on milling machine spindles is
  6. A foundation bolt with a circular end is secured to the floor by means of a steel cotter. If the pull on the bolt is 14000 kg, the diameter of the bolt should be
  7. Plastic deformation is
  8. In order to ensure leak proof mechanical links, the end of copper tubing in refrigeration cycle is
  9. Consider the following data pertaining to the production of a company for a particular month :?
  10. In a tug of war, five men pull a rope to the left at A and six moen pull the rope at B. A weight of 5 kg is hung vertically from the centre of the rope. In order that the rope AB be horizontal

Leave a Reply

Your email address will not be published. Required fields are marked *