A.1
B.2
C.3
D.4
E.None of the above
Related Mcqs:
- In case of belt drives, the effect of centrifugal tension is
- The belt drive can transmit maximum power when maximum total tension in belt equals
- If w is the angular velocity of the pulley and T1 and T2 are tensions of driving and driven side then power transmitted equals
- The horse power required to move a belt conveyor increases as
- Maximum horse power of a steam locomotive is
- On metre gauge, the maximum horse power of engine, on Indian Railways is around
- A circulating water pump of a condenser is of the centrifugal type and directly connected to a three phase induction motor running at 900 rpm. The pump delivers 30,000 litres per minute against the dynamic head of 10 m. The horse power of the motor required to drive the pump would be
- A single ply leather belt running at a belt velocity of 300 ft/min is likely to transmit per inch of width
- The coefficient of friction between pulley and belt is reduced to half. If the initial ratio of tension in belt is 5, then the new value will be
- The maximum power available in the wind is directly proportional to the velocity of the wind raised to the power
