A.pipe work
B.bends
C.drainage fittings
D.all of the above
Related Mcqs:
- The value of mannings roughness coefficient n, in Manning’s formula for flow of fluids through pipes, is expected to be highest in case of
- Which of the following pipe will corrode easily?
- Hammer blow in pipe occurs when
- When a strip made of iron and copper is heated
- In which of the following cases it is possible for flow to occur from low pressure to high pressure?
- A cannon of barrel length 2 m fires a shell of weight 6 kg with a muzzle velocity of 50 m/sec. The force exerted by the gases on the shell would be approximately
- A gun fires shell with a muzzle velocity of 600 m/sec. The angle of inclination of the gun so that the shell hits a target at a distance of 32 km at level 100 m higher than the gun would be approximately?
- Anchor blocks are provided to hold the pipe line so as to
- A thin cylinder contains fluid at a pressure of 30 kg kg/cm2, the internal diameter of the shell is 60 cm and the tensile stress in the material is to be limited to 900 kg/cm2. The shell must have a minimum wall thickness of
- A thin cylinder contains fluid at a pressure of 30 kg/cm2, the inside diameter of the shell is 60 cm and the tensile stress in the material is to be limited to 900 kg/cm2. The shell must have minimum wall thickness of
