A.100 N/mm2
B.200 N/mm2
C.400 N/mm2
D.800 N/mm2
Related Mcqs:
- A strip of steel 75 mm wide 40 mm thick is bent round a circular drum of 4.96 m outside diameter. If E = 2 x 105 N/mm2, the maximum stress due to bending will be
- The closed-coiled helical springs are made from the same small diameter wire, one wound on 2.5 cm diameter core and the other on 1.25 cm diameter core. If each spring has n coils, the ratio of their spring constants would be
- Two steel shaft each of length L and outside diameter D are subjected to uniform torsion. The first shaft is solid while the second one is hollow with inside diameter D/2. The ratio of the strain energies that these two shafts can absorb without exceeding a maximum allowable shear stress, would be
- A steel shaft 6 mm in diameter turns at 10,000 r.p.m. the safe working stress in shear is 350 kg/cm2. The maximum power that such a shaft may develop is approximately
- With a punch for which the maximum crushing stress is 4 times the maximum shearing stress of the plate, the biggest hole that can be punched in the plate would be of diameter equal to
- A short, hollow cast iron cylinder with a wall thickness of 1 cm is to carry a compressive load of 10 tonnes. If the working stress in compression is 800 kg/cm2, the outside diameter of the cylinder should not be less than
- A rectangular beam 200 mm deep by 100 mm wide-subjected to maximum bending moment of 500 kNm. The maximum stress in the beam will be
- If this shaft is to be replaced by a hollow shaft of texternal diameter 22 mm for the same maximum shear stress and same torque, the internal diameter will be
- For punching a hole of 25 mm diameter in a plate 20 mm thick, if the shear stress of plate material is 30 kg/mm2, the force required would be
- It is desired to punch a hole of 20 mm diameter in a plate 20 mm think. If the shear stress of mild steel is 30 kg/mm2, the force necessary for punching would be approximately in the range
