A.30 mm
B.60 mm
C.80 mm
D.90 mm
E.All of the above
Related Mcqs:
- A pressure vessel is said to be thin walled when the ratio of internal diameter of the vessel and wall thickness is
- A thin cylinder contains fluid at a pressure of 30 kg/cm2, the inside diameter of the shell is 60 cm and the tensile stress in the material is to be limited to 900 kg/cm2. The shell must have minimum wall thickness of
- A thin cylinder contains fluid at a pressure of 30 kg kg/cm2, the internal diameter of the shell is 60 cm and the tensile stress in the material is to be limited to 900 kg/cm2. The shell must have a minimum wall thickness of
- A short, hollow cast iron cylinder with a wall thickness of 1 cm is to carry a compressive load of 10 tonnes. If the working stress in compression is 800 kg/cm2, the outside diameter of the cylinder should not be less than
- The face temperatures of a flat wall are 650?C and 450?C respectively and the thermal conductivity of wall material is 0.30 kcal/m-hr-?C. For a wall thickness of 20 cm, the rate of heat conduction per square meter of wall area will be
- The surface temperatures of a flat wall are 650?C and 450?C respectively and the thermal conductivity of the wall material is 0.30 kcal/m-hr-?C. The heat flux for a wall of 20 cm thickness will be
- A vessel is said to be thin walled, when
- A compressed air cylinder carries approximately 70 kg/cm2 pressure at the time of delivery. The inside diameter is 25 cm. If the steel has a yield point of 2300 kg/sq cm and a safety factor of 2.5 the wall thickness should be
- What should be the thickness of a cast iron pipe 45 cm diameter if it is required to sustain 6 kg/sq cm inside pressure ? The maximum stress in the pipe material being limited to 140 kg/cm2
- The rate of heat loss through a furnace wall is 1000 kcal per hour when inside temperature is 1000?C and outside wall temperature is 500?C. What should be the wall thickness in case the thermal conductivity of wall material is 0.5 kcal/m-hr?C
