A.250
B.500
C.750
D.1000
E.5000
Related Mcqs:
- A solid shaft of 100 mm diameter transmits 100 HP at (450/?) r.p.m. The torque in kg-m on the shaft would be
- Two shafts of the same material are subjected to the same torque. If the first shaft is of solid circular section and the second shaft is of hollow section whose internal diameter is 2/3 of the outside diameter, the ratio of weights of hollow shaft to solid shaft would be
- Two steel shaft each of length L and outside diameter D are subjected to uniform torsion. The first shaft is solid while the second one is hollow with inside diameter D/2. The ratio of the strain energies that these two shafts can absorb without exceeding a maximum allowable shear stress, would be
- Two shafts are made of mild steel one having circular cross-section and the other shaft is hollow circular with inner diameter half of the outer diameter. The ratio of the torque that can be transmitted in two cases will be
- If this shaft is to be replaced by a hollow shaft of texternal diameter 22 mm for the same maximum shear stress and same torque, the internal diameter will be
- A steel shaft 6 mm in diameter turns at 10,000 r.p.m. the safe working stress in shear is 350 kg/cm2. The maximum power that such a shaft may develop is approximately
- A shaft running at 300 rpm is required to transmit 300 horse power. The working stress in shear is 420 kg/cm2. The diameter of the shaft whould be in the range
- In case of a circular shaft subjected to torque the value of shear stress
- A self-supporting steel chimney transmits the lateral forces to the foundation by
- A spring steel ribbon 3.2 mm wide, 0.5 mm thick is wound on a 500 mm diameter cylinder. If E = 2 x 105 N/mm2, the maximum stress in the steel will be
