A.Compression
B.Tension
C.Shear
D.Torsion
E.None of the above
Related Mcqs:
- Cemented carbide tools are generally not used for the machining of
- The binding material used in cemented carbide tools is
- If the life of high speed steel tools is taken as 100% the life of cemented carbide tools will be
- Eccentrically loaded columns are generally subjected to
- The coolant generally used while machining with carbide tools is
- In case of a knuckle joint the pin is likely to fail in
- The minor-diameter cross-section of the portion of the screw between the nut and the thrust bearing is subjected to
- When a nut is tightened by placing a washer below it, the bolt will be subjected to
- The loading on a pinion gear is usually
- The efficiency of a riveted joint is defined as the ratio of actual strength of the joint to that of solid plate. In this strength of the joint is considered in
