In a 48A 100-H-8-S-BE grinding wheel the type of bond used is

Production Engineering Mcqs
BILAL KHATTAK0

A.Vitrified
B.Silicate
C.Resinoid
D.Rubber
E.Shellac

Related Mcqs:

  1. A grinding wheel is rotating at 3000 rpm. When the switch is turned off the wheel stops in 10 seconds. The uniform deceleration of the wheel was
  2. The surface speed of grinding wheel in case of centreless grinding is
  3. A grinding wheel rotates at 3000 rpm. When power supply is cut off the wheel stops in 5 sec. The number of revolutions made by the wheel before coming to rest would be
  4. A grinding wheel rotates at 3000 rpm. When power supply is cut-off the wheel stops in 10 seconds. The number of revolutions made by the wheel before coming to rest would be
  5. In a 32A 49-H 8V BE grinding wheel the grit size is represented by
  6. In centreless grinding the regulating wheel is inclined at an angle
  7. The surface speed of regulating wheel in case of centreless grinding is
  8. Zeolite is
  9. In a single threaded worm and worm wheel the number of teeth on the worm wheel is 60. The diameter of the effort wheel is 12 cm and that of load drum is 8 cm. The velocity ratio will be
  10. In a single threaded worm and worm wheel the number of teeth on the worm wheel is 80. The diameter of the effort wheel is 12 cm and that of load drum is 8 cm. The velocity ratio will be

Leave a Reply

Your email address will not be published. Required fields are marked *