Gear tooth vernier is used to measure

Production Engineering Mcqs
BILAL KHATTAK0

A.Gear tooth profile
B.Gear tooth thickness
C.Pitch line thickness of gear tooth
D.Module
E.Addendum and dedendum

Related Mcqs:

  1. In case of spur gears the flank of the tooth is
  2. In case of gears the tooth fillet is
  3. In case of spur gears the profile is
  4. In case of spur gears the top land is
  5. The backlash between gears is expressed in terms of
  6. The radial depth of a ger tooth below the pitch circle is
  7. The thickness of a gear tooth is measured
  8. Stub tooth is
  9. Radial distance from the top to the pitch circle for a tooth is known as
  10. For two meshing gears, their

Leave a Reply

Your email address will not be published. Required fields are marked *