The edge of the plates for boilers and tanks are usually bevelled at an angle of 80?

Machine Design Mcqs
BILAL KHATTAK0

A.To reduce stress concentration
B.For safety
C.To facilitate joining
D.For fullering and caulking
E.None of the above

Related Mcqs:

  1. The edges of boiler plates for fullering and caulking are bevelled at an angle of
  2. Transverse slots are provided on a thread
  3. In a ball bearing a ball is subjected to
  4. The deductions for Employees Provident Fund start
  5. The rollers of a cycle chain are subjected to
  6. According to Kinetic theory of gases, at absolute zero
  7. Rupture stress is
  8. Floating heads are provided in heat exchangers to
  9. The angle of obliquity is kept small in order
  10. Hoop stress is

Leave a Reply

Your email address will not be published. Required fields are marked *