A.400?C
B.275?C
C.550?C
D.1000?C
Related Mcqs:
- A solid steel shaft of 100 mm diameter transmits 100 HP at (450/?) r.p.m. The torque in kg-m on the shaft would be
- Two shafts of the same material are subjected to the same torque. If the first shaft is of solid circular section and the second shaft is of hollow section whose internal diameter is 2/3 of the outside diameter, the ratio of weights of hollow shaft to solid shaft would be
- An unknown weight falls through 1 cm on a collar rigidly attached to the lower end of a vertical bar 3 m long and 6 m2 in section. If the maximum instantaneous extension is 2 mm the value of stress would be
- Quicklime is
- The slenderness ratio of vertical comumn of square cross-section of 2.5 cm sides and 600 cm length is
- The temperature based zone at an altitude of 10,000 is:?
- The classification of plant groups on the basis of temperature differentiating four zone such as megatherms was proposed by:?
- A shaft having one end fixed has a disc oscillating freely at the other end. If the shaft stiffness, increases the natural frequency of vibrations will
- The lead zone is a certain pyrometer is 0.125 percent of span. The calibration is 400?C to 1000?C. What temperature change might occur before it is detected?
- A steel shaft 6 mm in diameter turns at 10,000 r.p.m. the safe working stress in shear is 350 kg/cm2. The maximum power that such a shaft may develop is approximately
